Selected ATcT [1, 2] enthalpy of formation based on version 1.202 of the Thermochemical Network [3]

This version of ATcT results[3] was generated by additional expansion of version 1.176 in order to include species related to the thermochemistry of glycine[4].

Iodine cation

Formula: I+ (g)

CAS RN: 22541-93-1

ATcT ID: 22541-93-1*0

SMILES: [I+]

InChI: InChI=1S/I/q+1

InChIKey: OCVXZQOKBHXGRU-UHFFFAOYSA-N

Hills Formula: I1+

2D Image:

Aliases: I+; Iodine cation; Iodine ion (1+); Iodine atom cation; Iodine atom ion (1+); Atomic iodine cation; Atomic iodine ion (1+); Monoiodine cation; Monoiodine ion (1+)

Relative Molecular Mass: 126.903921 ± 0.000030

Δ_fH°(0 K)	Δ_fH°(298.15 K)	Uncertainty	Units
1115.549	1115.149	± 0.0062	kJ/mol

3D Image of I+ (g)

spin ON spin OFF

Top contributors to the provenance of Δ_fH° of I+ (g)

The 1 contributors listed below account for 90.0% of the provenance of Δ_fH° of I+ (g).

Please note: The list is limited to 20 most important contributors or, if less, a number sufficient to account for 90% of the provenance. The Reference acts as a further link to the relevant references and notes for the measurement. The Measured Quantity is normaly given in the original units; in cases where we have reinterpreted the original measurement, the listed value may differ from that given by the authors. The quoted uncertainty is the a priori uncertainty used as input when constructing the initial Thermochemical Network, and corresponds either to the value proposed by the original authors or to our estimate; if an additional multiplier is given in parentheses immediately after the prior uncertainty, it corresponds to the factor by which the prior uncertainty needed to be multiplied during the ATcT analysis in order to make that particular measurement consistent with the prevailing knowledge contained in the Thermochemical Network.

Contribution (%)	TN ID	Reaction	Measured Quantity	Reference
90.0	1285.1	I (g) → I+ (g)	Δ_rH°(0 K) = 84295.0 ± 0.5 cm-1	Radzig 1985

Top 10 species with enthalpies of formation correlated to the Δ_fH° of I+ (g)

Please note: The correlation coefficients are obtained by renormalizing the off-diagonal elements of the covariance matrix by the corresponding variances.
The correlation coefficient is a number from -1 to 1, with 1 representing perfectly correlated species, -1 representing perfectly anti-correlated species, and 0 representing perfectly uncorrelated species.

Correlation Coefficent (%)	Species Name	Formula	Δ_fH°(0 K)	Δ_fH°(298.15 K)	Uncertainty	Units	Relative Molecular Mass	ATcT ID
31.1	Iodine	I (g)	107.157	106.757	± 0.0021	kJ/mol	126.904470 ± 0.000030	14362-44-8*0
31.1	Iodine	I (g, 2P3/2)	107.157	106.757	± 0.0021	kJ/mol	126.904470 ± 0.000030	14362-44-8*1
31.1	Iodine	I (g, 2P1/2)	198.109	197.709	± 0.0021	kJ/mol	126.904470 ± 0.000030	14362-44-8*2
31.1	Diiodine	I2 (g)	65.497	62.417	± 0.0041	kJ/mol	253.808940 ± 0.000060	7553-56-2*0
30.7	Iodide	I- (g)	-187.996	-188.396	± 0.0021	kJ/mol	126.905019 ± 0.000030	20461-54-5*0
7.0	Diiodine cation	[I2]+ (g)	963.523	960.408	± 0.018	kJ/mol	253.808391 ± 0.000060	28712-14-3*0
5.0	Iodine monochloride	ICl (g)	19.024	17.391	± 0.013	kJ/mol	162.35717 ± 0.00090	7790-99-0*0
1.7	Hydrogen iodide	HI (g)	28.646	26.471	± 0.036	kJ/mol	127.912410 ± 0.000076	10034-85-2*0
1.4	Diiodine	I2 (aq, undissoc)		23.243	± 0.082	kJ/mol	253.808940 ± 0.000060	7553-56-2*1000

Most Influential reactions involving I+ (g)

Please note: The list, which is based on a hat (projection) matrix analysis, is limited to no more than 20 largest influences.

Influence Coefficient	TN ID	Reaction	Measured Quantity	Reference
0.997	1285.1	I (g) → I+ (g)	Δ_rH°(0 K) = 84295.0 ± 0.5 cm-1	Radzig 1985
0.239	1351.1	[I3]+ (g) → I2 (g) + I+ (g)	Δ_rH°(298.15 K) = 56.8 ± 2 kcal/mol	Thanthiriwatte 2014, est unc
0.025	2944.1	ICN (g) → I+ (g) + CN (g)	Δ_rH°(0 K) = 13.679 ± 0.045 (×2.327) eV	Dibeler 1967b, AE corr, est unc
0.002	1285.2	I (g) → I+ (g)	Δ_rH°(0 K) = 84294 ± 10 cm-1	Huffman 1967
0.001	6760.1	HCCI (g) → CCH (g) + I+ (g)	Δ_rH°(0 K) = 13.95 ± 0.50 eV	Baumgartel 1976, Allan 1977, Eland 1979
0.000	6353.1	CH3I (g) → CH3 (g) + I+ (g)	Δ_rH°(0 K) = 104395 ± 810 cm-1	Walter 1988, Tadjeddine 1982
0.000	1284.1	I2 (g) → I+ (g) + I- (g)	Δ_rH°(0 K) = 8.922 ± 0.013 eV	Myer 1970
0.000	1284.2	I2 (g) → I+ (g) + I- (g)	Δ_rH°(0 K) = 8.95 ± 0.02 eV	Morrison 1960
0.000	1285.3	I (g) → I+ (g)	Δ_rH°(0 K) = 10.43 ± 0.02 (×1.067) eV	de Leeuw 1978
0.000	1296.1	HI (g) → I+ (g) + H (g)	Δ_rH°(0 K) = 13.49 ± 0.13 eV	Eland 1977a
0.000	1291.1	I2 (g) → I- (g) + I+ (g)	Δ_rH°(0 K) = 8.933 ± 0.030 eV	Chupka 1971b

References

1		B. Ruscic, R. E. Pinzon, M. L. Morton, G. von Laszewski, S. Bittner, S. G. Nijsure, K. A. Amin, M. Minkoff, and A. F. Wagner, Introduction to Active Thermochemical Tables: Several "Key" Enthalpies of Formation Revisited. J. Phys. Chem. A 108, 9979-9997 (2004) [DOI: 10.1021/jp047912y]
2		B. Ruscic, R. E. Pinzon, G. von Laszewski, D. Kodeboyina, A. Burcat, D. Leahy, D. Montoya, and A. F. Wagner, Active Thermochemical Tables: Thermochemistry for the 21^st Century. J. Phys. Conf. Ser. 16, 561-570 (2005) [DOI: 10.1088/1742-6596/16/1/078]
3		B. Ruscic and D. H. Bross, Active Thermochemical Tables (ATcT) values based on ver. 1.202 of the Thermochemical Network (2024); available at ATcT.anl.gov
4		B. Ruscic and D. H. Bross Accurate and Reliable Thermochemistry by Data Analysis of Complex Thermochemical Networks using Active Thermochemical Tables: The Case of Glycine Thermochemistry Faraday Discuss. (in press) (2024) [DOI: 10.1039/D4FD00110A]
5		B. Ruscic, Uncertainty Quantification in Thermochemistry, Benchmarking Electronic Structure Computations, and Active Thermochemical Tables. Int. J. Quantum Chem. 114, 1097-1101 (2014) [DOI: 10.1002/qua.24605]
6		B. Ruscic and D. H. Bross, Thermochemistry Computer Aided Chem. Eng. 45, 3-114 (2019) [DOI: 10.1016/B978-0-444-64087-1.00001-2]

Formula

The aggregate state is given in parentheses following the formula, such as: g - gas-phase, cr - crystal, l - liquid, etc.

Uncertainties

The listed uncertainties correspond to estimated 95% confidence limits, as customary in thermochemistry (see, for example, Ruscic [5] and Ruscic and Bross[6]).
Note that an uncertainty of ± 0.000 kJ/mol indicates that the estimated uncertainty is < ± 0.000₅ kJ/mol.

Website Functionality Credits

The reorganization of the website was developed and implemented by David H. Bross (ANL).
The find function is based on the complete Species Dictionary entries for the appropriate version of the ATcT TN.
The molecule images are rendered by Indigo-depict.
The XYZ renderings are based on Jmol: an open-source Java viewer for chemical structures in 3D. http://www.jmol.org/.

Acknowledgement

This work was supported by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, Division of Chemical Sciences, Geosciences and Biosciences under Contract No. DE-AC02-06CH11357.