Selected ATcT [1, 2] enthalpy of formation based on version 1.122 of the Thermochemical Network [3]

This version of ATcT results was partially described in Ruscic et al. [4], and was also used for the initial development of high-accuracy ANLn composite electronic structure methods [5].

Species Name Formula Image    ΔfH°(0 K)    ΔfH°(298.15 K) Uncertainty Units Relative
Molecular
Mass		 ATcT ID
Ammonia anion[NH3]- (g)[NH3-]94.387.4± 2.4kJ/mol17.03111 ±
0.00022		37353-00-7*0

Representative Geometry of [NH3]- (g)

spin ON           spin OFF
          

Top contributors to the provenance of ΔfH° of [NH3]- (g)

The 5 contributors listed below account for 94.6% of the provenance of ΔfH° of [NH3]- (g).

Please note: The list is limited to 20 most important contributors or, if less, a number sufficient to account for 90% of the provenance. The Reference acts as a further link to the relevant references and notes for the measurement. The Measured Quantity is normaly given in the original units; in cases where we have reinterpreted the original measurement, the listed value may differ from that given by the authors. The quoted uncertainty is the a priori uncertainty used as input when constructing the initial Thermochemical Network, and corresponds either to the value proposed by the original authors or to our estimate; if an additional multiplier is given in parentheses immediately after the prior uncertainty, it corresponds to the factor by which the prior uncertainty needed to be multiplied during the ATcT analysis in order to make that particular measurement consistent with the prevailing knowledge contained in the Thermochemical Network.

Contribution
(%)		TN
ID		 Reaction Measured Quantity Reference
37.11142.9 [NH3]- (g) → NH3 (g) ΔrH°(0 K) = -1.41 ± 0.04 eVPuzzarini 2008
23.71142.8 [NH3]- (g) → NH3 (g) ΔrH°(0 K) = -1.349 ± 0.050 eVRuscic W1RO
14.01144.8 [NH3]- (g) → N (g) + 3 H (g) ΔrH°(0 K) = 245.90 ± 1.50 kcal/molRuscic W1RO
12.31144.7 [NH3]- (g) → N (g) + 3 H (g) ΔrH°(0 K) = 243.38 ± 1.60 kcal/molRuscic CBS-n
7.31142.7 [NH3]- (g) → NH3 (g) ΔrH°(0 K) = -1.438 ± 0.090 eVRuscic CBS-n


Most Influential reactions involving [NH3]- (g)

Please note: The list, which is based on a hat (projection) matrix analysis, is limited to no more than 20 largest influences.

Influence
Coefficient		 TN
ID		 Reaction Measured Quantity Reference
0.3711142.9 [NH3]- (g) → NH3 (g) ΔrH°(0 K) = -1.41 ± 0.04 eVPuzzarini 2008
0.2371142.8 [NH3]- (g) → NH3 (g) ΔrH°(0 K) = -1.349 ± 0.050 eVRuscic W1RO
0.1401144.8 [NH3]- (g) → N (g) + 3 H (g) ΔrH°(0 K) = 245.90 ± 1.50 kcal/molRuscic W1RO
0.1231144.7 [NH3]- (g) → N (g) + 3 H (g) ΔrH°(0 K) = 243.38 ± 1.60 kcal/molRuscic CBS-n
0.0731142.7 [NH3]- (g) → NH3 (g) ΔrH°(0 K) = -1.438 ± 0.090 eVRuscic CBS-n
0.0271144.4 [NH3]- (g) → N (g) + 3 H (g) ΔrH°(0 K) = 248.19 ± 1.60 (×2.134) kcal/molRuscic G4
0.0191142.4 [NH3]- (g) → NH3 (g) ΔrH°(0 K) = -1.202 ± 0.061 (×2.89) eVRuscic G4
0.0021144.6 [NH3]- (g) → N (g) + 3 H (g) ΔrH°(0 K) = 256.93 ± 2.16 (×5.657) kcal/molRuscic CBS-n
0.0021142.6 [NH3]- (g) → NH3 (g) ΔrH°(0 K) = -0.837 ± 0.092 (×5.907) eVRuscic CBS-n
0.0011144.3 [NH3]- (g) → N (g) + 3 H (g) ΔrH°(0 K) = 258.59 ± 1.72 (×8) kcal/molRuscic G3X
0.0011142.3 [NH3]- (g) → NH3 (g) ΔrH°(0 K) = -0.757 ± 0.085 (×7.336) eVRuscic G3X

References
1   B. Ruscic, R. E. Pinzon, M. L. Morton, G. von Laszewski, S. Bittner, S. G. Nijsure, K. A. Amin, M. Minkoff, and A. F. Wagner,
Introduction to Active Thermochemical Tables: Several "Key" Enthalpies of Formation Revisited.
J. Phys. Chem. A 108, 9979-9997 (2004) [DOI: 10.1021/jp047912y]
2   B. Ruscic, R. E. Pinzon, G. von Laszewski, D. Kodeboyina, A. Burcat, D. Leahy, D. Montoya, and A. F. Wagner,
Active Thermochemical Tables: Thermochemistry for the 21st Century.
J. Phys. Conf. Ser. 16, 561-570 (2005) [DOI: 10.1088/1742-6596/16/1/078]
3   B. Ruscic and D. H. Bross,
Active Thermochemical Tables (ATcT) values based on ver. 1.122 of the Thermochemical Network (2016); available at ATcT.anl.gov
4   B. Ruscic,
Active Thermochemical Tables: Sequential Bond Dissociation Enthalpies of Methane, Ethane, and Methanol and the Related Thermochemistry.
J. Phys. Chem. A 119, 7810-7837 (2015) [DOI: 10.1021/acs.jpca.5b01346]
5   S. J. Klippenstein, L. B. Harding, and B. Ruscic,
Ab initio Computations and Active Thermochemical Tables Hand in Hand: Heats of Formation of Core Combustion Species.
J. Phys. Chem. A 121, 6580-6602 (2017) [DOI: 10.1021/acs.jpca.7b05945]
6   B. Ruscic,
Uncertainty Quantification in Thermochemistry, Benchmarking Electronic Structure Computations, and Active Thermochemical Tables.
Int. J. Quantum Chem. 114, 1097-1101 (2014) [DOI: 10.1002/qua.24605]
Formula The aggregate state is given in parentheses following the formula, such as: g - gas-phase, cr - crystal, l - liquid, etc.
Uncertainties The listed uncertainties correspond to estimated 95% confidence limits, as customary in thermochemistry (see, for example, Ruscic [6]).
Note that an uncertainty of ± 0.000 kJ/mol indicates that the estimated uncertainty is < ± 0.0005 kJ/mol.
Website Functionality Credits The reorganization of the website was developed and implemented by David H. Bross (ANL).
The find function is based on the complete Species Dictionary entries for the appropriate version of the ATcT TN.
The molecule images are rendered by Indigo-depict.
The XYZ renderings are based on Jmol: an open-source Java viewer for chemical structures in 3D. http://www.jmol.org/.
Acknowledgement This work was supported by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, Division of Chemical Sciences, Geosciences and Biosciences under Contract No. DE-AC02-06CH11357.